Powered Line Array Speaker

Outdoor 12'' active speaker with dsp M-A3M

HF: 2x2.5"Neo, 8ohm 160W, Original Celestion Driver（CDX4-2420）from UK ,neodymium.

MF: 12"Neo, 500W ,Original Paudio Driver ,neodymium .

With 2 channel amplifier, Class-D, output power:600W+1200W.

With built-in DSP made in Germany.

Work with 518A together and play 3 way 12 inch active line array speaker system.

Used both outdoor and indoor.

Used for both small and big event.

INQUIRY EMAIL

Two-Way Active 12’’ Line Array Speaker with DSP
Model	M-A3M
Driver	MF: 12" , Neodymium, Paudio HF: 2x2.5", Neodymium, Celestion
Power(AES/Peak)	MF：500W/1000W HF：160W/320W
Sensitivity (1 W/m)	MF:106dB , HF:116dB
Rated Maximum SPL	MF:131dB / HF:136dB ( peak@1m)
Frequency Range	55Hz-20KHz (±3dB)
Dispersion angle(V × H)	H120°× V20°
Amplifier module 2ch (Class-D)	Power: 600W+1200W
	Impedance: 20KΩ (balance)
	Sensitivity: 0.775V
	Distortion: <0.05%
	Damping Factor: ≥400
	Power Connector:Power Con
	Voltage: 90~120V/190~240V
DSP processor	ALLDSP from Germany
Weight:	25Kg
Dimension	582×414×343mm

A3M is a small two-way active speaker system, providing a frequency range of 55Hz-20KHz, with smooth frequency and phase response, two 60mm neodymium magnets and a 12-inch neodymium woofer form a large dynamic headroom It greatly reduces the weight of the cabinet and provides a very high sound pressure and volume ratio.

A 500W 12-inch paper cone neodymium woofer is used in the mid-frequency part of the A3M. A specially designed mid-frequency phase plug is installed in front of the unit to prevent interference in the mid-band due to comb filtering and optimize the mid-frequency directivity. The high frequency part uses two 2.5" neodymium magnet compression units, combined with a plane wave-shaped translator, to produce a consistent wavefront.

A3M adopts an all-aluminum suspension system, which can make the adjustable angle of each cabinet 0-10 degrees. The cabinet is made of 13-layer plywood, and the surface is sprayed with wear-resistant and waterproof polyurea.

A3M has a built-in two-channel digital power amplifier module with 600W+1000W power as low frequency and high frequency separately. A one-in and two-out DSP digital audio processor module is used for tone correction, and system parameters can be adjusted through wifi and computer connection. . The power amplifier module has an LCD display.

It is suitable for small mobile performances, gymnasiums, theaters, bars, banquet halls and other places.

Previous：18'' active sub with dsp M-A2MS Next：Outdoor 18'' sub speaker with dsp M-A518A M-A918A

Inquiry:

Product name * :

Phone * :

E-mail * :

Message* :

Verification code* : 看不清？点击更换