Powered Line Array Speaker

10'' line array speaker with dsp M-A2M

HF: 2x1.75" Neo, 8ohm 75W, Original Celestion Driver from UK（CDX1-1730）, neodymium
LF: 12" Neo, 300W ,Original Paudio Driver ,neodymium
With 2 channel amplifier, Class-D, output power: 500W+800W,
With built-in DSP audio digital processor made in Germany
This is plug and play self-powered line array system. Sever for 200 to 3000 people.

INQUIRY EMAIL

two-way Active 10’’ Line Array Speaker with DSP
Model	M-A2M
Driver	MF: 10" , Neodymium HF: 2x1.75", Neodymium
Power(AES/Peak)	MF：400W/800W HF：150W/300W
Sensitivity (1 W/m)	MF: 104dB / HF:114dB
Rated Maximum SPL	MF:128dB / HF:135dB ( peak@1m)
Frequency Range	58Hz-20KHz (±3dB)
Dispersion angle(V × H)	H90°× V10°
Amplifier module 2CH (Class-D)	Power: 500W+800W
	Impedance: 20KΩ (balance)
	Sensitivity: 0.775V
	Distortion: <0.05%
	Damping Factor: ≥400
	Power Connector:Power Con
	Voltage: 90~120V/190~240V
DSP processor	ALLDSP from Germany, 1 input&2 output
Weight:	18Kg
Dimension	500×350×274mm

A2M is a small two-way active speaker system that provides a frequency range of 58Hz-20KHz, with smooth frequency and phase response. Two 45mm neodymium magnets and a 10-inch neodymium woofer form a large dynamic headroom The combination of, and greatly reduces the weight of the box, providing a very high sound pressure and volume ratio.

A 350W 10-inch paper cone neodymium woofer is used in the mid-frequency part of A2M. A specially designed mid-frequency phase plug is installed in front of the unit to prevent interference in the mid-band due to comb filtering and optimize mid-frequency directivity. The high frequency part uses two 1.75" neodymium magnet compression units, combined with a plane wave-shaped translator, to produce a consistent wave front.

A2M adopts an all-aluminum suspension system, which can make the adjustable angle of each cabinet 0-10 degrees. The cabinet is made of 13-layer plywood, and the surface is sprayed with wear-resistant and waterproof polyurea.

A2M has a built-in two-channel digital power amplifier module with 500W+800W power as low frequency and high frequency separately. A one-in and two-out DSP digital audio processor module is used for tone correction, and system parameters can be adjusted through RS485 connection with a computer. .

It is suitable for small mobile performances, gymnasiums, theaters, bars, banquet halls and other places.

Previous：Powered system 10inch line array & 18inch sub (M-L2 + M-L2S) Next：18'' active sub with dsp M-A2MS

Inquiry:

Product name * :

Phone * :

E-mail * :

Message* :

Verification code* : 看不清？点击更换